None of them, I don't have a FCC ID why should I ? I'm living in Europe so this is quite useless to me. (on top of that Europe and US models don't have the same specs/settings)
Hi Ricardo, as said, just take a cutter knife and gently (very gently) shave it until it passes without touching the gimbal. it's a pain to have to do that but it seems to be the quickest solution. I did it on mine, it's just fine. Then you can concentrate on the next problem... Initialisation...
http://www.globe-flight.de/Amimon-CONNEX-Latency-free-5GHz-Full-HD-Wireless-Video-System-with-SBUS-for-Gimbals-Groundend
From what I heard the ground unit alone will be available later.
I use a feelworld 7" with 5.8 receiver integrated. first try I couldn't get the HDMI video signal, the connex was displaying "Video not detected". There is a "camera" button on the feelworld, been pressing it and the video came... (???) I guess what comes out of the GH4 is not always directly...
Not a hero for me (a GH4) but both co-exist and no trouble. On the 900, the 2 transmitters are about 20cm apart, and I don't have any problem. However, I noticed that if the receivers were too close to each other, I was loosing the connex. Amimon recommends to keep them as far apart as possible...
Good news about the HDMI cable wrapping around the Z15 when initialising and moving the GH4, e-copter.com is about to release a system to install at the back of the gimbal that just remove the problem! Pls check it here: https://www.facebook.com/ecopterfr