Here is where we first tested RSGS with 1.2.2 firmware on av200
Almost no post stabilization, camera used was sony nex vg-20 with 18-200 lens with optical stabilization.
Here is another video with 1.2.2 firmware, but camera used was sony hdr-cx730 on av130 and no post stabilization at all
And...
Hi , Tom, i asked exactly same question few posts above. I Still didnt got answer.
I just installed 1.7b1 and its a lot better than 1.6. Will do some movies and post it soon.
So if anyone can tell us about aux feature, please do so :)
Thanks,
Robert
Hi there, i'm going to test 1.7b1 firmware now, but i have question about AUX Switch feature. Where the hell i have aux switch input in Skyline Harness?
Hi i did some testings, and for now AH switch both in software and OSD shows that it turns on. With only board connected to PC i lifted it from ground to about 2meters and it showed altitude change, and also passed diagnostics.
On our yesterday tests there was no sun at all, we tried also few...
Hi there HFP owners, i just recently update FW on my black board to 4.6, on GPS also, but i have problem, my altitude sensor doesnt work at all. It worked good on 4.3.860 tough.
Did all calibrations but on diagnostic tab all Gyro and Accelerometers pass but altitude not. When i switch to...
Thanks for answer. Our model is Droidworx AD8 Heavy lift with mikrokopter FC. Maybe if i will auto tune with setting XY not ideally flat but with some degrees to ground, Skyline could think that 10 degrees to bottom is "flat" for him :)
About tilt input, we connected tilt input to Tilt servo...
Hi there, i have a small problem with setting my max angles in SkyLine . We tested some angles and there are still booms on screen when our octo is at 45 degrees angle. In software i have default 90 and 0 values, i tried change values and its only changes base position of tray ;/ What i do wrong...