Clearing out my room of any parts i no longer need. Most have never been used or i over ordered. I dont mind posting over east. These are also listed on Gumtree but here is my short list
3.5mm Gold Connectors
$.40 per pair
FrSky 2.4G 2.4GHZ 4-channel Micro Receivers V8R4-II 4ch RX
$30
FrSky...
silly me
i found a better one anyway
http://www.ebay.com.au/itm/DJI-H3-3D-2D-Brushless-Gimbal-Adapter-Bracket-for-xaircraft-x650-Tarot-680-650-/271585928998?pt=Radio_Control_Parts_Accessories&hash=item3f3bc86726
i hope this is useful for someone else who is doing the some thing
Hi Does anyone know if this will suit a Tarot 680Pro Frame
http://www.aliexpress.com/item/free-shipping-Universal-Conversion-Plate-for-DJI-H3-3D-Gopro-Gimbal/2020411905.html
I found this and its exactly what i need to fit my Zenmuse
Hi Starting a new Build soon with a similar setup
Carbon Nylon 12x4.5" 1245 1245R CW CCW Propeller OR DJI 10"
Afro ESC 30Amp Multi-rotor Motor Speed Controller (SimonK went with these because i saw someone that could fit them under the motors. i just think they look a lot neater
SUNNYSKY...
I did find this on a page but i would probably buy this when i have more coin. cheap - medium parts will do for now. Man those motors are expensive must be good then
Recommended configuration:
- 8x Sunnysky 4014-12 320kv motor: http://www.foxtechfpv.com/sunnysky-v...tor-p-863.html $668. 64...
As i am happy with my DJI Naza f450 I now want to add no more to it and go to a Tarot T1000 frame,
now some of u may say i am crazy especially being a bit of a newbie but i have done a bit of research and i think i have it mostly thought out. If anyone has attempted to build it pleas your...
Hi Everyone this is my second post
my first was my first build please check it out if you wish
http://www.multirotorforums.com/showthread.php?20136-First-Build-DJI-F450-NAZA-V2&p=168928#post168928
I have to say very impressed on DJI parts however want to start a build on a Tarot t1000 frame...
Hi Everyone
I am from Perth, Western Australia and this is my first build on any multicopter. also hope to find anyone in Perth that is doing similar copter.
My first build has cost me around $1800 so far (way more then what i thought i would spend but not regretting though)
below is my...
hi guys i am perth too. been doing a lot of research on the DJI f550 and thought i would give that a shot. I been mucking around with the AR drone i have had enough of its short range wifi system so want to upgrade. Hopefully get the kit to make myself and we shall see what happens