Recent content by Parker Brown

Four CW/CCW Pairs of T-motor Carbon Props sized 16x5.4 I bought these new and never even opened the packaging on three of them. The one I did open was just to take the attached pics, so never mounted or flown and they include all the little bits that come with them. $220 for all of them...

Hey guys, I fly a X8 Vulcan with WKM over a Movi M5/GH4. My current issue is this: When I push forward on the stick the craft moves forward and then starts to list to the left (roll not yaw). When I push backwards on the stick the craft moves backwards and then lists right. When I push left it...

Problem Solved. Ya, that was the result of the config error...no response from the Tx in the Assistant. It's the most obvious things you forget to mention :) So after 7 hours of going back and forth between the copter and the internet I found this: http://www.saetechnologies.com/cfg-err-naza/...

Thanks for the response, but I'm still at a loss. I've gone through the binding procedure many times with two different Tx's (DX8 & DX7s) with the same poor results. Setup is Gear = U, Aux2 = X2, Aux3 = X3. Gear is setup as failsafe to the Mix switch, and I'm pulling the bind plug and...

I'm using this same custom mix on a 10kg x8. Works well. I'm restricted on prop size (vulcan mantis arms), and I had the same idea about changing top motor speeds to 90% or so to offset coaxial efficiency loss. Have you seen a gain with this strategy? I don't think DJI has any integrated way...

Hello everyone, I've been flying a Vulcan UAV X8 that I built about 6 months ago with no issues until today. I was curious about setting up a model in my DX8 in Heli mode to try to access throttle curves. I made a new Heli model in the Tx and bound it to the Rx. Now when I power up the...