Hey Bartman
I watched your Video Part 6 of tuning KK boards. You mentioned you were using stock settings. What are the gain settings? Could you tell me what they are I have the same copter but with the kk 2.15. Also do you have a video about setting up a gimbel with the kk boards
I have a naza m v2 and DYS 40 amp opto simon K on my octocopter
I calibrated each ESC seperatly and they all started up. then soldered all the wires to a power dist board.
I did a motor test and all motors were turning the correct direction.
When I go to start the motors they will not...
I am going to build a big Octocopter with 4114 320 kv motors with a 6S battery I was wondering what size wire I should use for the motors to ESC. Also what size power distribution board? Any suggestions welcome.
Thanks
Mark
I hovered my hex copter yesterday and after about 20 seconds in the air it would glitch. The copter would pitch forward and backwards about 15 degrees then it would hover nice and stable for about 30 seconds, then it would do it again. During the flight the green lights were flashing the whole...
I have always used an old piece of carpet while flying Helicopters. You can get that for free from someone that replaces there carpeting. I would stake it down for the big helicopters/multirotors.
i would get some motors from hobby king they are allot cheaper and from the experience of buying over 25 motors of various types I have never had a problem.
just my 2cents
good luck with your build.
Can anyone tell me if it is ok to use XT60 conectors on 4s 4000 ma battery, or 4s 5000ma. I noticed that the batteries less than 3000 ma use XT60 but if you get anything higher than 3000 ma they use the big red connectors from hobby king.
Thanks
Mark