Recent content by Greg

Okay.Will leave as is.I appreciate the reply.

Tarot 650 I have X4108S 600KV sunnys and have some 1455 on the way 4S 5000 (AUW 2300) Would having longer arms provide better stability?This is a very slow flying build. Here is mock prop setup pic 14'' http://imgur.com/fSJDngM

I came across this.Sounded interesting for those of us that dont like the 50% throttle takeoff.I ahave a few minis and like the linear throttle 100% better then nazas 50% thing. First get gps homelock (repetitive greens)switch to manual,arm in manual mode,bring throttle up 3/5% then switch to...

I already have 1344 Beechwood props.My AUW is 2172(680 alien)I have tried Ecalc but not really sure how accurate.I bought and tried MT2814 770KV Tigers but are not effecient and too much thrust and use almost double amp then these pancake style motors.It would really help me if someone can take...

New frame but same naza.I flew my Tarot in manual but just maidened this 680 alien yesterday.It has a Yaw issue that seems to be common with longer body H frames with naza.Once I iron that out,if that is doable then I will see how manual flys and what my loiter % is.Thanks for reply.

With nazas 50% stick untill taking off (I hate this BTW)how do you determine what throttle hover percent is.Do you have to be in manual mode to get accurate estimate of how much throttle is needed to maintain hover?

This is my fourth quad build and second using Naza.This build consists of 770kv tigers.Everything is ready to fly except I dont want to maiden as the idle motor speed(lowest setting naza software)seems too fast.I am using the taranis with sticks calibrated to default.I just think it will take...

I think it had something to do with using the servo tester before soldering motors

Solved.I calibrated that one motor and all is good.I figured that the esc was calibrated with this setup on another frame it would have been calibrated still.I guess a frame swap requires recalibration of esc's

This is a direct swap from tarot 650 to larger frame so all the softawre is configured already and checked in the NAZA V2 software.3 motors spin on arming in correct directions.All 4 motors and esc's worked with servo tester when checking motor rotation pre soldering.I have checked esc servo...

I know exactly how the naza works and the difference between flight modes but I read somewhere how someone configured/hacked the naza to not goveren the throttle in atti mode.Perhaps this is total bullshit but he had the same throttle response in atti as you would in manual.He had this >(just...

I am not trying to accomplish but asking if there is a way to have the same type of throttle response in atti mode as it has in manual mode.The throttle has a lot more power in manual mode vs atti.When I give full throttle in manual it rockets vs atti it is slower.This is naza.Probaly not doable...

I have looked into this,but is it possible?.Would there be a way of having the same throttle power in atti mode.I suppose if you had the throttle esc directly into receiver would do it but this would be extremly dangerous as the flight controller wouldint be able to monitor and control...

I currently have the naza V2 and wold like another.Seeing as the lite would be cheaper that is what I am looking for .Thanks

I have it sorted.With 1355 props manual mode is roughly 60/65%.I switched to 1365 and it hovers @ about 55% and I can decend at a quicker rate without swashing about.If I need to get down really quick I come down on angle.The times are pretty near the same.I also cut down the arms so now I have...