Recent content by flipporabasta

wrong part of the forum i posted in, or?

kind of new to multirotors etc, but whats the advantage of having 2xmotors/props per arm? seen a few of those machines when scooping around the net. An also, when lifting 20kg, wont the flighttime be highly reduced? //Newbie with a lot of questions d.s impressive machine that was....

Hi Need some advice regarding the placement of ESC and PowerDistributionBoard. I have a Tarot FY690S frame, and i bought the Gryphon Power Distribution Board (GPD-1000HXP). The board was a bit bigger than i thought so im not really sure about the best placement for it. And i have been thinking...

Hi im kinda new to this. well not so new to multirotors, but the heavier lift stuff. today i own a dji naza f550 V2, no gimbla but a fixed gopro mount on a landing gear. Im currectly looking towards a system that can handle my Eos5D. was in contact with the local dealer, they said i should go...

Another extremly nice landing gear can be found at aeroxcraft.com. Bought one myself and I'm really pleased. The detail and fitting of that is outstanding, not sure if it is cheap or expensive. To me it was worth every pound. They also sell a go pro gimbal for it(excl servos) for a reasonable...

managed to get the thingy in the air today :D weeeeee in atti mode it seems rocksolid. didnt have a real change to test it properly though, cause my batt ran out. had to move around some props that where on the wrong motor etc (did crash it last week, 1 arm and 3 props gone). Need to get some...

ok now i follow you. What i ment with "trim it", it was when i had to set the gearswitch in the right position(Attitude and Manual). played around with the settings a bit and understand some more about it, but ill give it a go with the default settings at first. p.s but if there is a JR owner...

Ok. I had to change(trim it) the gear value in the tx so that it would fall under Attitude and Manual. It is the same for the gains?

No :D i have a JR DSX9 MKII and i've set them on AUX1 and 2. i guess that will be a 3 switch. i have seen the gains change, but i cant change the values.

Hi. after a few flight i discovered that i have forgotten to connect the gains to aux1 and 2(that probably explains the numerous crashes i already have had :D ). now that i have done that i am a bit confused. Those settings doesn seem to be configurable in my machine. or does it suppose to be...