Recent content by DLien

Can anyone provide any info on which A2 multi-rotor configurations will tolerate a motor failure? By "tolerate" I mean that a motor can fail and the rig will remain airborne and will remain controllable. I know that DJI began supporting motor failures with the WKM on X6 ships in course lock...

Can you shed any light on what testing DJI has been done? Just trying to build on your experience. Knowing the extent of the testing performed might instill some confidence.... just an idea.

Funny guy... I'll be putting the "Adapter plates" back the way they were delivered....

I am wondering where I have gone wrong. I have the S900 with the longer legs and the Z15 for the NEX7 mounted but the mount is still hitting the ground when it initializes. When I mounted the Z15, I turned what I am going to call "the adapter plates" upside down so that the countersink for the...

Is it possible to balance these props? That might cut down on the vibrations...

Hmm.... i was using on the first flight to monitor voltage levels, did have telemetry working yet. I didn't try a flight with was connected but didn't have any indications that it wouldn't work. Path Trace worked just fine.

Ed, Can you tell us what the length of the original gear leg and the length of the longer replacement tubes?

Has anyone seen this error message outside the assistant software when testing the failsafe? ======================== Error The receiver may be disconnected during use. For the external receiver users, please check the receiver connections. For the A2 built-in receiver users, please contact...

Is this is still available?

PM Sent

Any chance of getting the internal resistance in the batteries?

Hi, Is this still for sale?

Being new to the 3DR world flight controllers, what is the difference between the older Mission Planner vs the APMPlanner2? I know that APMPlanner2 can be used with a Mac system, but is that it? Will one or the other be phased out or go unsupported at some point? Which one should people use...

After I corrected an error in the IMU orientation, it calibrated just like it always has. Now I can tell you what happens when that setting is incorrect. :black_eyed: It's not pretty!

What firmware are you on running on these units? Is it the same on both? I had the same thing happen right after loading v5.26...