Recent content by bostonkiter

Ronan Thank you for the well wishes. I agree with the philosophy of redundancy, however, this $3000.00 component worked for about a dozen flights and stopped working without provocation. I've spoken to DJI and the dealer. Each blames the other for the lack of support and we're stuck in the...

No luck. I mapped the AUX1 channel and tried it in on/off positions without luck. Both 5Ds don't work with it. Two Vtxs don't work. It's a $3000.00 paperweight that'll take 6-8 weeks to fix. Not happy.

I'll certainly look later on and report back! Thanks bro!!!

Thanks guys. scotth- The Zenmuse doesn't support HDMI. I'm not sure what you mean by your comment. Can you explain further? Thank you!

We've been flying an S1000 with the Z15 5D successfully for a few months w/o any issues of any kind. Seemingly for no reason, the Z15 stopped communicating with the Cannon 5D. The camera settings are exactly to spec for DJI use and the machine is otherwise unchanged. However, the 5D scene...

Carapau saved the day. I simply missed a fundamental channel error. This is an event that largely goes under reported. -I made a mistake- A2 didn't let me take off- Well done dji!

I've set a few up on S1000s and cannot figure this one out! I've done: Updated all the components Sticks cal ok (14SG) IMU cal inside Compass cal outside All motors passed F/S IOC and fight modes all functioning normally Home position indicates saved Rotors won't spin.... Any ideas...

Thank you very much for the information. The only issue is that it does not show that the system goes into failsafe when I turn off the transmitter. It remains in whatever flight profile I have left in.

There's a fantastic video that I didn't bookmark. The guy explains the procedure of how to setup a 14SG w/ A2 to kick on RTH. Does anyone know how?! Thanks!

Thanks for the thoughts, Craig! I swaped both the RX and tx without any changes. I have a new sat ant to try. Ill let you know how that goes!

I wish. I've swapped out all the components. I'm really disappointed that it didn't work out. I have no magic bullet as of yet. Have you tried swapping out your controller?

Check this out, this is what the channels look like when I'm plugged in! This can't be good and is likely contributory. But I don't know what the source is. And yes I have recalibrated a bunch and it does this every time. http://youtu.be/U4Wir_P7tao

Thanks Bob! I'll trial those settings.

Not sure what you mean by "blips". ?? Do you mean some kind of interferance or flashing of the pointer on the throttle scale?

First off, thank you to all who have been very helpful with my previous posts! I've got a professinally built f550 with the following: NAZA-M V2 Heavy lift- T-Motor MN3510-13 KV700 x6, TMOTOR Carbon 12-4 x6 Zenmuse H3-2D Gaui Vision 100 5.8ghz Pulse 6600mAh Naza M V2 Settings...