After a prop failure I did a rebuild and one motor wouldn't spin up. I thought it was a bad ESC so i replaced it. That wasn't the problem. Noticed this hairline crack in the board where that exact motor arm mounts. Can this be repaired with solder or do I need a new bottom plate?
DJI Distribution board small crack.....Can it be fixed?
- Thread starter Still pro
- Start date
kloner
Aerial DP
man, thats flirting with danger.
what about sanding the covering off the positive ring behind the crack and soldering the input on there and then fixing the boards crack with solder. Couldn't have been in a worse spot, whats the other side look like? is the ground comprimised too?
what about sanding the covering off the positive ring behind the crack and soldering the input on there and then fixing the boards crack with solder. Couldn't have been in a worse spot, whats the other side look like? is the ground comprimised too?
Yeah, its the arms and both boards. Better be safe than sorry right.