unf0rg0tt3n
Member
Hi All,
Since a while ago I built my own drone but it got some problems... After a long while I figured it all out and now everything is working.. except flying the thing.
Two days ago I began working on my drone again and went back to my design table. Made a 3D print for my drone so now the body is fully 3D printed, hooked up everything again and fired it up.
Everything working again except the fact that the thing wont fly because it got like over a bazilion more %%% of power to One rotor.
I got the DJI E310 tuned propulsion system (Quad) and DJI naza M-Lite.
Everything hooked up by manual.
Drone gave response to my input with remote, but kept giving 200% power to one rotor.
Electrical power output is what it has to be on each seperate ESC, and used a multimeter to confirm.
Please help me, I'm on the brink of throwing the drone into the garbage.
Since a while ago I built my own drone but it got some problems... After a long while I figured it all out and now everything is working.. except flying the thing.
Two days ago I began working on my drone again and went back to my design table. Made a 3D print for my drone so now the body is fully 3D printed, hooked up everything again and fired it up.
Everything working again except the fact that the thing wont fly because it got like over a bazilion more %%% of power to One rotor.
I got the DJI E310 tuned propulsion system (Quad) and DJI naza M-Lite.
Everything hooked up by manual.
Drone gave response to my input with remote, but kept giving 200% power to one rotor.
Electrical power output is what it has to be on each seperate ESC, and used a multimeter to confirm.
Please help me, I'm on the brink of throwing the drone into the garbage.