I assembled my new Flamewheel F450 last night. Everything went together really good. But I have a few questions regarding the setup with my controller and Dji assistant.
I have a Futaba with a 8-ch S-Buss receiver. I have it connected thru the S-Buss. I have adjusted all the end points in my radio and asigned the 2 3-position switches.
When I have it all plugged into the computer. The icon for the GPS.Atti.Manual will flicker to the position the switch is in and FailSafe. Is this normal, this flickering? The led on the Quad stays the same.
Also after I arm the motors, if I lower the throttle to 0% they will not restart without rearming them. This is normal?
Thanks
I have a Futaba with a 8-ch S-Buss receiver. I have it connected thru the S-Buss. I have adjusted all the end points in my radio and asigned the 2 3-position switches.
When I have it all plugged into the computer. The icon for the GPS.Atti.Manual will flicker to the position the switch is in and FailSafe. Is this normal, this flickering? The led on the Quad stays the same.
Also after I arm the motors, if I lower the throttle to 0% they will not restart without rearming them. This is normal?
Thanks