Quad stuff:
DJI F450 w/NAZA M GPS/Compass
Zenmuse H3-3D gimbal w/Hero 3+ Silver
Futaba 8FGSuper
Firmware updated. Hero 3+ Silver updated. Ran all the Assistant stuff.
Problem:
When I plug the cord from the gimbal into the Hero 3+ Sliver, it 'locks the camera'(I have to remove the battery to reset the camera). Thoughts please?
The camera works fine as long as I do not plug it in....regardless whether or not it is sitting in the gimbal. But the plug from the gimbal is supposed to be plugged in for a reason...right? It does not matter what settings the TX is in(or even if the TX is on/off). I have tried plugging it in after/before battery installation for the quad...no difference. Every time 'locked'!
Experts, please tell me what step I'm missing.....please.
Scott (frustrating me to a beer...) B
DJI F450 w/NAZA M GPS/Compass
Zenmuse H3-3D gimbal w/Hero 3+ Silver
Futaba 8FGSuper
Firmware updated. Hero 3+ Silver updated. Ran all the Assistant stuff.
Problem:
When I plug the cord from the gimbal into the Hero 3+ Sliver, it 'locks the camera'(I have to remove the battery to reset the camera). Thoughts please?
The camera works fine as long as I do not plug it in....regardless whether or not it is sitting in the gimbal. But the plug from the gimbal is supposed to be plugged in for a reason...right? It does not matter what settings the TX is in(or even if the TX is on/off). I have tried plugging it in after/before battery installation for the quad...no difference. Every time 'locked'!
Experts, please tell me what step I'm missing.....please.
Scott (frustrating me to a beer...) B