Hey folks. Quick question about setting the Zenmuse's travel limits.
Equipment: Phantom with upgraded board and Zenmuse H3-2D, no Zenmuse GCU needed. I'm using the NAZA-M V2 software for calibration.
I can't seem to set the travel limits. The GoPro points way to far upwards. I'd like to limit this to point slightly down from horizontal. In the Naza software (Advanced > Gimbal), I've changed the Pitch F2 maximum and minimum values, but nothing seems to change on the Zenmuse (nor does any other setting on this page). Any advice?
Thanks in advance!
Equipment: Phantom with upgraded board and Zenmuse H3-2D, no Zenmuse GCU needed. I'm using the NAZA-M V2 software for calibration.
I can't seem to set the travel limits. The GoPro points way to far upwards. I'd like to limit this to point slightly down from horizontal. In the Naza software (Advanced > Gimbal), I've changed the Pitch F2 maximum and minimum values, but nothing seems to change on the Zenmuse (nor does any other setting on this page). Any advice?
Thanks in advance!