Aeronavics / Droidworx XM - X4 Okto Build

[Marown]

Hello everybody!

I am attempt to build a new Droidworx X8 the XM - X4
I will take sopme 400kv Motors and 15x5 Propellers with an A2
Also i will take the Extended retraicable landing gear from droidworx and the zenmus z15 adapter.

I am hoping to get a fligthtime up to 18 minutes with 2 times 8000 mAh 6s Lipos.

my question where the hack should i place the two Lipos???
I seen some plates you can mount on the arms on the sky jib but will it wor for the XM - X4 koax?

What setups are you flying ?

regards
Marown

 

[Bluerex]

Hi Marown,
I DW sell battery mount plates that bolt to the deck flush with the tops of the booms.
http://aeronavics.com/products/shop/ad-new-accessories/boom-battery-mounting-plate-xm/
REMEMBER to order 2 of them
I am not sure you will fit 15 inch props on an XM - 12 or 13 are most likely the max.