I have just tried the altitude limit function of firmware 5.16 which worked like a charm.
I had it set to 20 metres and sure enough during a climb it just stopped ascending. I looked at my Spektrum altimeter and it measured about 20m :nevreness:.
I pushed the throttle to max and as expected it didn't climb but suddenly there was a very brief burst of full power. It was really quick and immediately settled back to hover power but had pulled enough current to trigger the first stage warning from fresh batteries. This quickly returned to normal and I went on to get the expected length of flight from the batteries.
During the flight I tried 'more than hover throttle' at the height limit again and each time got a brief blip of power.
Now I'm aware this happens I can be careful but I think it could be a problem if a large unexpected current draw happens towards the end of the flight and it triggers the second level protection.
I'll raise this with DJI & report back.
I had it set to 20 metres and sure enough during a climb it just stopped ascending. I looked at my Spektrum altimeter and it measured about 20m :nevreness:.
I pushed the throttle to max and as expected it didn't climb but suddenly there was a very brief burst of full power. It was really quick and immediately settled back to hover power but had pulled enough current to trigger the first stage warning from fresh batteries. This quickly returned to normal and I went on to get the expected length of flight from the batteries.
During the flight I tried 'more than hover throttle' at the height limit again and each time got a brief blip of power.
Now I'm aware this happens I can be careful but I think it could be a problem if a large unexpected current draw happens towards the end of the flight and it triggers the second level protection.
I'll raise this with DJI & report back.