Hi all, I have just build a new 8x 400 kv 13,4.5 blades.
I'm having altitude trouble with the Wookong M V5.26.
I started with 6s. Flies wonderful but in GPS and Atti mode the Altitude is all over the place.
I then tried 4s to see if the rig is over powered. Still flies nice but same problem.
At one point it shot up 100+ meters without and input.
I have tested the rig for vibration as this can cause Altitude issues but it is very low vibration.
Also when landing slowly it sometimes slams into the ground, same issue.
Can't get my head around this one.
The higher the Altitude gain the worse it gets. Gain right down to 50% and still very jumpy.
Any ideas?
p.s. Using Custom setup as the Dji default is terrible.
Throttle Yaw Pitch Roll
M1 100 100 ‐50 ‐50
M2 100 ‐100 ‐50 50
M3 100 100 50 50
M4 100 ‐100 50 ‐50
M5 100 ‐100 ‐50 ‐50
M6 100 100 ‐50 50
M7 100 ‐100 50 50
M8 100 100 50 ‐50
thanks
Anthony
I'm having altitude trouble with the Wookong M V5.26.
I started with 6s. Flies wonderful but in GPS and Atti mode the Altitude is all over the place.
I then tried 4s to see if the rig is over powered. Still flies nice but same problem.
At one point it shot up 100+ meters without and input.
I have tested the rig for vibration as this can cause Altitude issues but it is very low vibration.
Also when landing slowly it sometimes slams into the ground, same issue.
Can't get my head around this one.
The higher the Altitude gain the worse it gets. Gain right down to 50% and still very jumpy.
Any ideas?
p.s. Using Custom setup as the Dji default is terrible.
Throttle Yaw Pitch Roll
M1 100 100 ‐50 ‐50
M2 100 ‐100 ‐50 50
M3 100 100 50 50
M4 100 ‐100 50 ‐50
M5 100 ‐100 ‐50 ‐50
M6 100 100 ‐50 50
M7 100 ‐100 50 50
M8 100 100 50 ‐50
thanks
Anthony