Very Happy with my Latest Build

AlienNet

Member
Hi Everyone, i would just like to tell you about my latest build, it is a 650mm RC Timer Carbon Fiber Frame, i used longer 16mm CF Legs bringing the Dia: to 750mm, Motors are Tarot 4006/620KV , ESCs are ZTW Spider 40a, Props CF 13 X 5, Naza M Lite & Spektrum AR8000 Receiver, Total Weight with Turnigy 5000 4s 25c Lipo is 1830g, i took it out today for its maiden flight, and to say i was pleased would be an understatment, i set the timer on my Spektrum DX8 for 10 mins, hoping that it would fly this lenght of time, it flew beautifully with all naza gains set at 150, i did a mixture of hovering and agressive flying, after 10 mins my Tranny started to vibrate, but my naza LED remained Flashing Green, i continued flying until it started to flash red then landed, i could hardly believe it, it was in the air for a full 21 minutes, i am just Delighted with my new Bird, the Lipo is brand new and i believe that LiPos get a little bit better after a few charges, i dont know how to post a picture here or i would do so.
Thanks for Reading my Happy Story.
 
Last edited by a moderator:

Bartman

Welcome to MultiRotorForums.com!!
congrats on the successful build AlienNet. the batteries will improve a little after a few charge cycles so that 21 minutes might go to 22 or 23.

what other builds have you done and how does the NAZA Lite compare to them?
 

AlienNet

Member
Hi Bartman, i am charging the 5000mah @ 4a, i have built quite a few quads & hex,s, i have 1 flying Dji F550 1 Dji F450, and a couple of part built 550s, also built a couple of 700mm quads from scratch inc: the frames CF,, i also recently sold a CF 700 Size H4, the list really does go on lol.. i have always used the Naza M Lite, i think that for value its hard to beat, i have played around with other boards eg: KK2 & Arduino, but prefer the Naza.
 

Top