Mikrokopter Updating Firmware

R

RBlax

Member
Probably has been asked, but do you have to re-calibrate your FC board after the update? I haven't read this anywhere.

I'm having issues with my Navi not connecting following the update. Trying to figure that out now.
 

R

RBlax

Member
I think my Navi is froze up!

Is there a way to re-flash the firmware? I can't get it to connect to MK-Tool
 

R

RBlax

Member
[h=2]Got it!!

Manual reset[/h]The connection is fine but the automatic update does not work anyway?
If after "Connecting (try to reset hardware and start bootloader)..." is not an "OK" coming up after ~3 to 4 dots than you can do as follows:


  • connect the PCB (i.e. FC) over the ribbon cable direct to the MK-USB (not over a wireless connection!). For the BL-Ctrl use the connector on the side of the MK-USB!
  • remove jumper from MK-USB
  • In the KopterTool select the appropriate file and start the update
  • place the jumper while the dots been displayed
 

You must log in or register to reply here.
Top