williammiller
Member
Checking to see if anyone has been successful in running the naza software on a Mac computer with Parallels. Before I go and buy a small windows based laptop, I installed Parallels and then was successful in downloading naza assistant and firmware 4.02. After I connect the naza to the mac the LED changes from blinking orange to steady green. But there is no connectivity...when I click "test motors" I get message stating "please connect to controller". I have uninstalled and reinstalled the software and get the same message. I was successful in connecting when I used a friends PC laptop.
Seems like I am close to saving a few hundred bucks but not quite there.
So...anybody out there know if I'm barking up the wrong tree?
Thanks. B.
Seems like I am close to saving a few hundred bucks but not quite there.
So...anybody out there know if I'm barking up the wrong tree?
Thanks. B.