Turnigy 9X v2 Channel 3 mix with Channel 6

[Marek]

Hey Guys,

Have a hard time trying to figure this out ... When I select a HELI mode on my Turnigy 9X v2 Mode2 with original FW and set up AUX CH6 - PIT TRIM, my throttle (CH3 influence the CH6) and PIT TRIM just adjust the CH6 output a little bit. (See the video). This is happening only if I have heli mode selected, ACRO is all right.

This might be some stupid mistake but couldn't find any solution so far how to disable this mix.

http://www.youtube.com/watch?v=zbxHa8z0jHc

<object width="480" height="360">

</object>Cheers,
Marek

 

[RTRyder]

The short answer is you can't disable that mix in heli mode, its there to make sure throttle increases along with collective and is part of the programming in the firmware.

Sent from my MB855 using Tapatalk 2