Taranis X9D question

G

gomotomoto

Member
Just picked up a Taranis X9D and a FrSky X8R 16CH Smart Port Telemetry receiver.

I'm going to use this for a DJI F550 build. This post may belong in the beginners forum, so if any admin needs to move it...

Can anyone point out if I'll need to purchase any other add-ons so I can read onboard battery voltage? I'm new at this so don't fully understand yet and trying to learn as much as possible here.

Also, does anyone have any info on the steps needed to bind this to a NAZA flight controller (V2).

Again, this may belong in the beginners lounge, but since it seems a bit more complicated, I figured it belonged here.

Thanks for any help or links pointing in the right direction.
 

T

tahoelight

Member
Hey G ;p

Not sure if you need a sensor or the voltage monitoring for telemetry, but I do know your Naza does not need to be bound. Just your radio and receiver get bound together. Then is will send the signal you input into your radio to the Naza. It will be more clear when you get it installed.
 


You must log in or register to reply here.
Top