FlyEYE
Member
Yesterday after rebuilding my MK on the weekend I was hovering in my house, everything was good. I wanted to test the emergency gas so I held on to my MK and shut off the TX. The MK stopped right away instead of staying on the 20 seconds or so. Tried it a couple times and still didn't work. I figure I must have changed something in MKTOOLS.
Having not changed anything, I tried to hover again today and, what the heck... Nick and Roll where reversed, and... emergency gas was working. After a couple power cycles of the TX and MK, everything is now working properly. Any ideas what's going on?
As for rebuilding, I was trying to land the MK and forgot to turn off position hold and altitude hold and it was bouncing off the ground pretty good (which I assume is normal). It then shot up full power into the air flipped onto a roof. Ended up blowing a BL-CTL 1.2, busting an arm and one motor is now a little noisy (slightly bent shaft?). Could this be related?
I'm using a 9CHP with spektrum module. Never had an issue with it on my helis.
Firmware on the MK is .78, one of my 1st thoughts is to put in .82 (along any other updates) just in case.
Having not changed anything, I tried to hover again today and, what the heck... Nick and Roll where reversed, and... emergency gas was working. After a couple power cycles of the TX and MK, everything is now working properly. Any ideas what's going on?
As for rebuilding, I was trying to land the MK and forgot to turn off position hold and altitude hold and it was bouncing off the ground pretty good (which I assume is normal). It then shot up full power into the air flipped onto a roof. Ended up blowing a BL-CTL 1.2, busting an arm and one motor is now a little noisy (slightly bent shaft?). Could this be related?
I'm using a 9CHP with spektrum module. Never had an issue with it on my helis.
Firmware on the MK is .78, one of my 1st thoughts is to put in .82 (along any other updates) just in case.