Hello
Every now and then after a crystal clear pic and between 1 and 300 metres (so anywhere) - maybe after 2 minutes, 5 minutes, whatever - this happens:
OSD is in the Video, but this happens also when directly connected to the camera without anything inbetween.
When I unplug power and replug the receiver it DOES NOT help.-
Only help: Re-power both TX and CAMERA! (Kind of hard to do in the air...)
Do you have ANY idea what I could change or what's the matter?
On the net I only found THIS:
http://fpvlab.com/forums/showthread....highlight=sync
unsolved
http://www.rcgroups.com/forums/showthread.php?t=1637601
unsolved
Equip:
ImmersionRC TX
ImmersionRC Duo5800 (2011)
I tried with 25mw, 100mw, 600mw. All the same. I tried with duck, patch, spiro antennas. All the same.
I tried 4 cameras - no change.
It MIGHT drops out when I change direction with the aircraft but I am not sure...
Thank you for your help!
Every now and then after a crystal clear pic and between 1 and 300 metres (so anywhere) - maybe after 2 minutes, 5 minutes, whatever - this happens:
OSD is in the Video, but this happens also when directly connected to the camera without anything inbetween.
When I unplug power and replug the receiver it DOES NOT help.-
Only help: Re-power both TX and CAMERA! (Kind of hard to do in the air...)
Do you have ANY idea what I could change or what's the matter?
On the net I only found THIS:
http://fpvlab.com/forums/showthread....highlight=sync
unsolved
http://www.rcgroups.com/forums/showthread.php?t=1637601
unsolved
Equip:
ImmersionRC TX
ImmersionRC Duo5800 (2011)
I tried with 25mw, 100mw, 600mw. All the same. I tried with duck, patch, spiro antennas. All the same.
I tried 4 cameras - no change.
It MIGHT drops out when I change direction with the aircraft but I am not sure...
Thank you for your help!
Last edited by a moderator: