shed- head on crash

[dazza22]

hi everybody .
everything been working great , since last post .
ii have flown about 81/2 hour , and getting abit too cocky.
yesterday i flown into the shed doors .
anyway today with new props went back out to play .
and things are not wright .the quad wants to yaw to the right .
it was windy out but i dont think that was the cause .
so i check the quad again and 1 of the motors as a lot of play ,you can pull the can partof motor and get about 2mm of gap between can and base of motor.

could this be the cause of the yaw problem ?

cheers dazza
forgot to mention setup
quadframe 600mm
naza
2212 motor
hobbywing skywalker 20a
9x5 props

 

[mailman35]

sounds like you bent the shafts.

 

[dazza22]

sounds like you bent the shafts.

thanks for help , the motors are the cheap 2212 1000kv with yellow ends ,
is it easy to change the shafts (are shafts available ) or is it wiser just to change motor ?
cheers darren

 

[mailman35]

depends, ive had no luck removing the shaft from the stock dji's but if anything it just comes to finding the size and diameter of the shaft and removing the set screw that holds it in place.