Severed motor wire in crash, repair?

E

Elliott000

Member
I severd a couple wires on a couple of my axi motors in a crash, can i just splice em up and solder then heatshrink? Are there better methods...
Thanks
 

J

jes1111

Active Member
Depends if it's the silicon multi-strand that broke (in which case, sure - splice and get back in the air) or the motor winding wire itself where it comes out of the bottom of the motor(in which case you'll need to strip the shellac coating and effect a very careful twist/splice - really tricky, not guaranteed to hold up).
 


M

mailman35

Member
yeah i had a motor wire that got 3/4ths of the way sliced through by an arm, i havent fixed it yet. just swapped for another.
 

You must log in or register to reply here.
Top