srbell
Member
Thought I'd start a new thread from the return home problem as this very well could be totally unrelated, but keeping my unit grounded all the same. When I plug in my WooKong to the computer, the assistant software shows a RX-ERR and channels 1-5 are all going crazy with no radio input. Here's the facts lol:
-Futaba sbus reveiver.
-MZ 14 transmitter.
-WooKong M FC
-sbus decoder (3 channel) for shutter release.
Things I've tested:
-Re binded the receiver, changed to another receiver and tried a different transmitter.
-Checked if the sbus signal could be corrupt. So I programmed the sbus decoder to operate on channels 1-3, this gives me a side by side comparison of how Futaba and the WK unit are decoding the signal. This was really interesting as 1-3 in the assistant software are going crazy, but the servos hooked up the the decoder operate normally. Makes me think somehow the WKm is unable to decode the sbus signal. Why would the futaba decoder work and the WKm FC won't?
-Maybe the software is faulty? Tested the gimbal servos direct to the sbus decoder and operates normally. Plug it into the WK, and the gimbal goes nuts! So what's being displayed in the assistant software is accurate.
-Tried new firmware and recalibration all with no luck.
HELP!
-Futaba sbus reveiver.
-MZ 14 transmitter.
-WooKong M FC
-sbus decoder (3 channel) for shutter release.
Things I've tested:
-Re binded the receiver, changed to another receiver and tried a different transmitter.
-Checked if the sbus signal could be corrupt. So I programmed the sbus decoder to operate on channels 1-3, this gives me a side by side comparison of how Futaba and the WK unit are decoding the signal. This was really interesting as 1-3 in the assistant software are going crazy, but the servos hooked up the the decoder operate normally. Makes me think somehow the WKm is unable to decode the sbus signal. Why would the futaba decoder work and the WKm FC won't?
-Maybe the software is faulty? Tested the gimbal servos direct to the sbus decoder and operates normally. Plug it into the WK, and the gimbal goes nuts! So what's being displayed in the assistant software is accurate.
-Tried new firmware and recalibration all with no luck.
HELP!