Hello,
Problem:
Over the last few weeks I have been building a quadrotor, but i have come across a problem! The quadrotor doesn't seem to keep its height, I use the kk2.1.5 chip which i know doesn't have a altitude lock but it should at least stay in the air. I have tryed messing with the PI settings and its a little better but not what i would like. The quad seems to either get to height then stay hovering for about 3-5 seconds then drops slowly to the floor then when it drops sometimes stays there and sometimes goes back up. The other problem I am having is the throttle either being to low or to high meaning one setting the quad drops to the floor and one more notch up and it goes soaring into the sky.
My Build:
What i have tryed
Thanks in advance,
Joe
Problem:
Over the last few weeks I have been building a quadrotor, but i have come across a problem! The quadrotor doesn't seem to keep its height, I use the kk2.1.5 chip which i know doesn't have a altitude lock but it should at least stay in the air. I have tryed messing with the PI settings and its a little better but not what i would like. The quad seems to either get to height then stay hovering for about 3-5 seconds then drops slowly to the floor then when it drops sometimes stays there and sometimes goes back up. The other problem I am having is the throttle either being to low or to high meaning one setting the quad drops to the floor and one more notch up and it goes soaring into the sky.
My Build:
- HobbyKing X666 Frame
- KK2.1.5 preflashed with stevis 1.8
- Hobbyking power distroboard lite
- turnigy plush 25amp esc
- NTM prob drive 28-26 1350KV/302W
- 10x4.5 SF props
- Turnigy 9x controller
What i have tryed
- Factory resetting - different pi settings
- Calibrating Esc's
- Different Controller
- Different battery
Thanks in advance,
Joe