Problem with engine or power or i don't now

maxivila

New Member
I have this problem with my DJI Phantom


I used it in the early evening and the next day I get this.
I do not know what to call this problem that makes it very difficult to me to find some solution on the Internet.
I hope someone can guide me or help me fix it
Just four months of use.
It was never used in rain or fog.
The motors rotate perfectly if the spin by hand, they are not hard or locked.
Never before something happened to me, or any other error.
I tried to reinstall the firmware 4.02 and also did a downgrade to 3.0 and nothing changes, everything remains as seen in the video.
I think it's something on the motherboard or the NAZA ...
I don't know what else to try.

thks
 
Last edited by a moderator:

Cheshirecat

Member
Wow i was expecting to see one of the rotors not turning properly (not all 4) probably discounts the motors or Esc's so could be a fault with a bad power connection or signal lines to/from the Naza.
have you opened it up to check all the connections are seated correctly.
Do all the channels respond properly when hooked up to the software, That should eliminate the radio if they are, maybe the motors are not arming properly at >10% throttle.
Be careful with it if the props are on, if it doing unpredictable things it could suddenly throttle up and lift off if you haven't taken them off already.
 

maxivila

New Member
Wow i was expecting to see one of the rotors not turning properly (not all 4) probably discounts the motors or Esc's so could be a fault with a bad power connection or signal lines to/from the Naza.
have you opened it up to check all the connections are seated correctly.
Do all the channels respond properly when hooked up to the software, That should eliminate the radio if they are, maybe the motors are not arming properly at >10% throttle.
Be careful with it if the props are on, if it doing unpredictable things it could suddenly throttle up and lift off if you haven't taken them off already.

I find the problem
I take off the props guards and put the large screws with out the guards in the phantom. The screws go to inside the motors and make a short circuit.

The prop guard screws are too long and will pierce the motors windings.
The solution: motors must be replaced.

http://www.amazon.com/T-Motor-MN221...e=UTF8&qid=1384283790&sr=8-2&keywords=tmotors
 
Last edited by a moderator:

Top