I bound my AR9020 receiver to my DX18 using a radio pack. I then plugged one of the satellites into my pixhawk (as per direction) in my F550. Ran the setup wizard in Mission Planner and the pixhawk is receiving no commands from the DX18.
Any suggestions on how to get this to work?
edit: it appears that pixhawk software currently does not support over a DX8. Is there any way to get the DX18 working with the pixhawk? Can I use a PPM encoder?
Any suggestions on how to get this to work?
edit: it appears that pixhawk software currently does not support over a DX8. Is there any way to get the DX18 working with the pixhawk? Can I use a PPM encoder?
Last edited by a moderator: