Tomas Varin
New Member
Hi There, this is my fist post.
1) I bought a Phantm 2 Vision+ in Las Vegas (USA) and fly with no problem.
2) I bring to Buenos Aires (Argentina) and try to fly again (without any calibration)...
3) The Phantom fly crazy and crash. The gimbal camera was damage
4) After this crash, I can use the phantom and the camera with some small problems (like "Gimbal motor error"), and I have to loose a little some screws from the gimbal base so the gimbal arm doesn't touch the gimbal base.
5) It wasn't perfect, but I can use the phantom, film, move the camera. The only problem was that the camera was a liitle twisted, but that was the only big problem.
6) I connect the Phantom to PC and update the firmware
7) After update, I loose control on the camera. I cannot move anymore and if I activate the Camera gimbal control switch (the one that moves the camera with the movement of the phone), the camera looks dows and stays there. I cannot recover.
Here is a video that explain better the story:
- Does anybody know how to solve this?
- How can I go back to the original firmware? Is there a site where I can found old firmware release history?
Thanks!
Tomas
1) I bought a Phantm 2 Vision+ in Las Vegas (USA) and fly with no problem.
2) I bring to Buenos Aires (Argentina) and try to fly again (without any calibration)...
3) The Phantom fly crazy and crash. The gimbal camera was damage
4) After this crash, I can use the phantom and the camera with some small problems (like "Gimbal motor error"), and I have to loose a little some screws from the gimbal base so the gimbal arm doesn't touch the gimbal base.
5) It wasn't perfect, but I can use the phantom, film, move the camera. The only problem was that the camera was a liitle twisted, but that was the only big problem.
6) I connect the Phantom to PC and update the firmware
7) After update, I loose control on the camera. I cannot move anymore and if I activate the Camera gimbal control switch (the one that moves the camera with the movement of the phone), the camera looks dows and stays there. I cannot recover.
Here is a video that explain better the story:
- Does anybody know how to solve this?
- How can I go back to the original firmware? Is there a site where I can found old firmware release history?
Thanks!
Tomas