Paralyzed Gimbal Controller after firmware update

808dave

Member
Hello everyone, I've been using a Goodluckbuy board recently, which was working ok, however I couldn't connect to make adjustments in SimpleBGC GUI. I finally figured out my connection/driver issue and wanted to make some small adjustments. I flashed it with SimpleBGC 1.3b1 Null using Xloader and still was able to make adjustments in SimpleBGC GUI 1.3. I should have left it there, however I got curious and wanted to experiment with Arduino. I flashed it with a recent firmware and since then my controller has been paralyzed, unable to revert to any other firmware or run any GUI. Im getting the "GUI vs Board Version Mismatch" error. I've tried nearly every combination of firmware/gui i can think of. If anyone has any experience with this issue, I'm open to any suggestions. Thanks and take care.

edit: I wanted to add that the gimbal currently has a random twitching, which pauses while I attempt to load firmware. So there is still some sort of communication between the controller and computer.


Dave

My board is pictured below.

View attachment 14089
 

Attachments

  • BGC_dimg.jpg
    BGC_dimg.jpg
    34.5 KB · Views: 385
Last edited by a moderator:

Top