Welcome To DroneVibes

DroneVibes is a COMMUNITY of drones enthusiasts. We are experts at drones for all professional and consumer applications. We welcome you to register and join the conversation.

XAircraft OSD FPV horizon line not level

Discussion in 'General Drone Manufacturer Discussion' started by traxx2003, Mar 30, 2015.

  1. traxx2003

    traxx2003 Member

    111
    6
    1
    Mar 30, 2015
    California
    Posted by traxx2003, Mar 30, 2015 #1
    My FPV Horizon line is not level, always tilted like on the picture below. The picture was taken while hovering in GPS hold, on 2mph winds.
     

    Attached Files:

    Tags:
  2. X650Mouse

    X650Mouse Take no prisoners

    438
    10
    1
    Nov 13, 2013
    Australia
    Posted by X650Mouse, Mar 31, 2015 #2
    What flight controller?

    X
     
  3. traxx2003

    traxx2003 Member

    111
    6
    1
    Mar 30, 2015
    California
    Posted by traxx2003, Mar 31, 2015 #3
    It is a SuperX controller
     
  4. X650Mouse

    X650Mouse Take no prisoners

    438
    10
    1
    Nov 13, 2013
    Australia
    Posted by X650Mouse, Mar 31, 2015 #4
    Never read of that problem before with SX, I assume you have checked all the obvious like FC center of the vehicle facing up and forward, no major electrical interference present. the level is taken from the FC not the OSD, the vehicle was in flight when you took the picture what about putting it on a level surface

    X
     
  5. traxx2003

    traxx2003 Member

    111
    6
    1
    Mar 30, 2015
    California
    Posted by traxx2003, Mar 31, 2015 #5
    Correct, the weird thing about it is that when I first power up, the line will be level, but after 20-30 seconds you can watch the line slowly going off the level position. That picture was taken while hovering, in a no wind condition.
     
Loading...

Share This Page

Loading...