Pfuschendennarr
Member
Hi guys,
Disaster has stuck.
While rebuilding my f550 on clean plates with new motors I messed up bad.
Despite it being the 5th time, i soldered my managed to solder ALL of my esc's backwards.
I plugged in my battery only to see a the sparks, hear a pop, and yank it out.
I looked at the board to see that it had peeled up integrated board material just above the positive connection (the only thing properly soldered on was the voltage cable.
At this point, I thought it was because I connected the battery wrong (I had a deans cap on my dean, before docking deans and assumed i reversed polarity) <- dont worry that isnt relevant anymore
So, thinking I had just reversed the battery polarity, I soldered accross the gap, and plugged it in. This.... was an expensive mistake as it short circuited the battery, heated up the leads and blew the failsafe on my battery. (6600 4s is now a brick)
Realizing the escs were on backwards (and kicking myself) I resoldered them on correctly and When plugged in I get the motor sounds powering up, the startup lights, and then the red flashing.
The naza lite assistant reads a voltage error, and when I check the voltage, it is reading 0.0 with a charged 3s plugged in.
Does anyone have experience with this problem, and do you think I burnt out either my pmu or naza lite?
The software is receiving all of the tx data from the dx6i and everything seems fine EXCEPT that the naza is getting no voltage... which is a bit confusing to me.
A second opinion from the local hobby shop yielded no definitive answer except that I might have somehow fried the PMU (or lite)
I was thinking of, and am now rushing to go ahead and get the nazav2 but if theres some way to salvage this bust I would love the advice.
Thanks!
Disaster has stuck.
While rebuilding my f550 on clean plates with new motors I messed up bad.
Despite it being the 5th time, i soldered my managed to solder ALL of my esc's backwards.
I plugged in my battery only to see a the sparks, hear a pop, and yank it out.
I looked at the board to see that it had peeled up integrated board material just above the positive connection (the only thing properly soldered on was the voltage cable.
At this point, I thought it was because I connected the battery wrong (I had a deans cap on my dean, before docking deans and assumed i reversed polarity) <- dont worry that isnt relevant anymore
So, thinking I had just reversed the battery polarity, I soldered accross the gap, and plugged it in. This.... was an expensive mistake as it short circuited the battery, heated up the leads and blew the failsafe on my battery. (6600 4s is now a brick)
Realizing the escs were on backwards (and kicking myself) I resoldered them on correctly and When plugged in I get the motor sounds powering up, the startup lights, and then the red flashing.
The naza lite assistant reads a voltage error, and when I check the voltage, it is reading 0.0 with a charged 3s plugged in.
Does anyone have experience with this problem, and do you think I burnt out either my pmu or naza lite?
The software is receiving all of the tx data from the dx6i and everything seems fine EXCEPT that the naza is getting no voltage... which is a bit confusing to me.
A second opinion from the local hobby shop yielded no definitive answer except that I might have somehow fried the PMU (or lite)
I was thinking of, and am now rushing to go ahead and get the nazav2 but if theres some way to salvage this bust I would love the advice.
Thanks!