No Motor Action - WKM

[DIPswitch]

I get cell count

I get GPS calibration confirmation

I have nothing when I give stick command to start motors.


I simply entered into the assistant and thought of making some changes , but didnt.
When I went to spin motors, its like its not even plugged into power.
I dont get it. It flew just fine a few hours ago.

all lights seem to be acting like nothing is wrong.

thanks

 

[olof]

Move both sticks down and out. This will start the motors, when not connected to the Assistant. You then have a few seconds to move above 10% to keep them going.

It is in the manual.

I always clamp the MR to a table or remove blades before testing a new MR.

Make sure all the blades spin in the right direction and behave correctly before attempting flight.

 

[DIPswitch]

I understand that stick command. Its what ive been doing the whole time.
This is not a new multi rotor. this has been flown for over 6 months.

 

[DIPswitch]

...

 

[DIPswitch]

AH HA ! I gave the controller some expo for manual flying and when I added that to elev/ale. I was no longer able to start with sticks.
I had to switch to different mode to get sticks to work.


is adding dr/expo to controller the way to soften stick commands in manual flying?