Giovanni59
Member
I just installed the Naza V2 on the Hexacrafter 650. First I kept getting error message 27 that I needed to do advanced calibration of the IMU and no matter how many times I did it it still kept saying I need to do it. I did many times and kept recycling the power and finally I got the copter to react to the TX. I flew a few times, played around with the gains on FC and gimbal and then when I went to fly it idled up but would not react to the TX. I couldn't even turn it off. I had to reach underneath and unplug the power. When hooked up to assistant I get "CFG-ERR Caused either by upgrading firmware of a faulty TX configuration". I can't configure the TX because it is not getting a signal from the TX. I tried rebinding the TX several times and nothing. Now what?