Josh Rottman
New Member
I just installed a brand new H3-3D gimbal on my Phantom 2 and I am having issues where it either points straight forward or straight down and there is no tilt in between, it just jumps from one to the other. I have updated the firmware on all three pieces (copter, gimbal, RC), calibrated everything, and still no luck.
Also, in the Assistant Software, under Advanced > Gimbal > Gimbal Config all the numbers are grayed out despite the software recognizing the copter. Does this mean it isn't reading the gimbal or is this normal? Changing the values doesn't seem to do anything.
Lastly, I'm having an issue where sometimes the battery and the Phantom don't seem to be speaking to each other. I go through the power up phase and the copter doesn't respond. Sometimes it does though. Very strange. Is the battery supposed to blink immediately when connected to the charger?
Also, in the Assistant Software, under Advanced > Gimbal > Gimbal Config all the numbers are grayed out despite the software recognizing the copter. Does this mean it isn't reading the gimbal or is this normal? Changing the values doesn't seem to do anything.
Lastly, I'm having an issue where sometimes the battery and the Phantom don't seem to be speaking to each other. I go through the power up phase and the copter doesn't respond. Sometimes it does though. Very strange. Is the battery supposed to blink immediately when connected to the charger?