Hello all. I am in the process of designing a gizmo to work along with the X650 line of multirotors. Going on sale sometime spring 2013. Currently I have it designed to fit the DJI F550 but want to adapt it to work with the X650 also. My problem is I dont own a X650!
Anyways looking for some dimensions
1) Diameter (OD) of carbon rods that run front to aft. The ones that landing gear and gimbals connect to...
2) Separation distance of these two rods? Center to center.
3) Separation distance of the stock xaircraft X650 landing gear. From the inner edge of front set to the inner edge of the rear set...
4) Distance from the bottom of the rods that run front to aft to the floor. Basically how much space exists under the craft.
Also a close up picture of the underside of this craft will REALLY help me out too! Your help is greatly appreciated!
Anyways looking for some dimensions
1) Diameter (OD) of carbon rods that run front to aft. The ones that landing gear and gimbals connect to...
2) Separation distance of these two rods? Center to center.
3) Separation distance of the stock xaircraft X650 landing gear. From the inner edge of front set to the inner edge of the rear set...
4) Distance from the bottom of the rods that run front to aft to the floor. Basically how much space exists under the craft.
Also a close up picture of the underside of this craft will REALLY help me out too! Your help is greatly appreciated!