NAZA will not arm - unsure of light error

v1stacruiser

New Member
Can anyone help me out here? I've flown my f450 with new NAZA installed with no issues about 10 times and now it won't arm and I haven't the slightest about the light code error. I'm guessing it may be a bad receiver or no signal at this point. If you could help me out that would be great.
I've included a video to help.
Thanks.
 
Last edited by a moderator:



Confirm in the assistant software that all the channels move correctly according to your stick and switch movements. Do a Advanced IMU calibration and then the stick calibration. Be sure you can move it in and out of Failsafe mode. Once ready to fly perform the compass calibration.

Do you have an OSD if so it will tell you what mode you are in ie GPS ATI or failsafe. will also show battery voltage and if in battery failsafe mode
 

v1stacruiser

New Member
Yes. Everything was moving correctly in the software. I thought you meant the Assistant Software would give me an error or the like.
I have yet to do the Adv. IMU calibration. I'll do that this evening.
I don't have an OSD but I have my switches setup for GPS, Atti and Failsafe.
Just wish it would go back to flying again.
 


Top