Naza V2 TX Calibration

[term_paint]

I upgraded my firmware from v1 to v2. My problem is when i first went to tx calibration it was jumping all over. After i did the calibration everything seemed good but prior they were all jumping back and forth?? Should i be concerned.

 

[Rotorfreek]

No you shouldn't. Before you calibrate your sticks, it has no idea how far you have to full input positions.

Therefor it may be massively overestimating what it thinks it's your input, but is infact just signal noise.

V2.02 is solid as a rock - don't worry.

Sent by my thumb, a trusty slave to my crazy mind. The above is the ramblings of a lunatic, and should be treated as such. Terms and conditions apply.

 

[term_paint]

Thanks