Hi Guys,
I have never had a LED module go bad but when I plug this into the USB nothing happens it just keeps blinking and does not connect to the computer. I am very experienced with the DJI software in terms on driver installs and firmware upadates etc. I have done everything tried multiple computers and usb cables and nothing is working. Is it possible that the LED has gone bad even though I was just using it the other day without any problems to adjust stuff in the assistant software? You can trust me when I say all my solders are good the PMU is powered and everything is wired correctly. Its just really strange when I plug it into the LED nothing at all happens. The computer does not recognize a thing. Any help or suggestions besides that basics? Thanks
I have never had a LED module go bad but when I plug this into the USB nothing happens it just keeps blinking and does not connect to the computer. I am very experienced with the DJI software in terms on driver installs and firmware upadates etc. I have done everything tried multiple computers and usb cables and nothing is working. Is it possible that the LED has gone bad even though I was just using it the other day without any problems to adjust stuff in the assistant software? You can trust me when I say all my solders are good the PMU is powered and everything is wired correctly. Its just really strange when I plug it into the LED nothing at all happens. The computer does not recognize a thing. Any help or suggestions besides that basics? Thanks