NAZA-M V1, can't setup RC calibration

ikidd

New Member
I have a Naza-m, V1 with the 4.02 FW on it. I can't seem to get the inputs for the 9XR radio to calbrate to the center. I had it at one point, but then it seemed to have lost it's memory and it's been impossible to put back. I've reflashed the controller and reset everything I can find and it won't seem to recognize that the sticks are centered. I go through the calibration procedure repeatedly, but it never seems to get the limits right and keeps the sliders out of the center.

Here is a pic of the http://i.imgur.com/PgXnvOL.jpg controller screen after a few attempts at calibration.

I've tried various things on the radio, reset it, created new mixer profiles, nothing seems to get it to go.

How do I go about getting it fixed or warrantied if it wasn't me? All I've really done here is put the RX to Input lines on. The motors seem to function fine, but because of the calibration issue, I can't seem to arm the motors in regular use. This also assumes that I don't need the GPS in order to use this controller, I didn't bother getting one because I just plan for close flying for now.
 

Top