Newbie here: I just bought a previously "built & tested" f450 w/gps, naza, gimbal, fpv. Came with spectrum rx but I have a futaba t8j so I replaced the rx w/ futaba 8ch rx. I have no response except that the gimbal works. NO throttle. rx lights up green the VU flashes (I think GPS error) and when I disconnect the gps from naza I still get an red/amber single flash. Ideas?
naza/futaba set up but no response except gimbal
- Thread starter jackster
- Start date
STI-REX
Gettin Old
I take it you know about the control stick command that is required to arm the motors , Mine is both sticks down and to the center
Do you have the manual
http://www.dji-innovations.com/products/naza-multi-rotor/downloads/
Have another read it will help you to understand the lights sequencing on the "VU"
Also did you reverse the throttle channel in the radio settings on the TX not the assistant (Futaba is reversed compared to Spektrum on the throttle channel)
Do you have the manual
http://www.dji-innovations.com/products/naza-multi-rotor/downloads/
Have another read it will help you to understand the lights sequencing on the "VU"
Also did you reverse the throttle channel in the radio settings on the TX not the assistant (Futaba is reversed compared to Spektrum on the throttle channel)