Naza CSC for motors start/start seem inverted.

[SmackHappy]

My first build, trying to get my first flight.
As the topic says, CSC seems inverted.

Vitals:
f450, Naza v2 + GPS, Taranis x9d tx & x8r rx.

Are there any channels I need to inverse? Im guessing there are, For example Ch3. But are there others? If so, please lend a hand!

Here is how I have it Currently set up:
*Ch1*
A (Left/Right on right Stick)
Rest = 0, All Right = 1000, All Left = -1000

*Ch2*
E (Up/Down on right Stick)
Rest = 0 All Up = -1000, All Down = 1000

*Ch3*
T (Up/Down on Left Stick)
Rest = NA (No Return), All Up = -1000, All Down = 1000

*Ch4*
R (Left/Right on Left Stick)
Rest = 0, All Right = 1000, All Left = -1000

*Ch5*
(X1) (Left Nob above stick. For Gimble)
Nob All Left -1000, Nob All Right = 1000

*Ch6*
(X2) (Right hand 3 way switch. For ioc)
Up = off, Middle = Course Lock, Down = Home Lock

*Ch7*
(U) (Left hand 3 way switch. For Control Mode)
Up = Man, Middle = Atti, Down = GPS


I set it up according to this thread:
http://www.multirotorforums.com/sho...tructions-for-FrSky-Taranis-X8R-and-Naza-M-V2
(Big ups to Gringers!).

He only says to inverse ch6 (ioc) (SG) which I did to make it Up = off, middle = Course Lock, Down = Home Lock.

My Mom says I should just hold the TX upsidedown.
Seems legit.

Thanks guys!

 

[Crisp image]

Connect it to the NAZA assistant and when the stics are moved the slider should move the same way.
For T if you push the throttle up you should see an increase to the right
A push he stick left the slider should go to the left.
E push up an it should increase to the right
R push to the left and it should indicate left

Anything that is not right reverse the channels either on your Tx or in the Naza Assistant
Hope this helps
Regards
Crispy

 

[SmackHappy]

Beautiful. That works.
Does anyone know if there's a best practice between inverting by the assist app vs inverting on the tx?
Thanks again!


Sent from my iPhone using Tapatalk

 

[PeteDee]

With the Naza it matters not at all.