My quad crashed again.... For no reason

traw1234

Member
So this quad has been quite a bit of trouble to me, but I am figuring it out. 3 times in the 4 days, I was flying it and it just drops out of mid-air. The first time it just broke an arm, but I fixed it. Yesterday it got stuck in a tree, but I resoldered and ESC and fixed it. Today it dropped from about 25 feet in an open field. Most of the frame is broken... I am running off of a CC3D. I have absolutely NO idea why this is happening, and I would love to hear some thoughts.



Here is a video from the second time it happened. Though it may look like it hit the tree, I was watching it and it was about 3 feet above it. I just got lucky...

https://vid.me/fnkg
 

jbrumberg

Member
Traw1234- Welcome to the forum.

I think that it would help for you to describe in greater detail your crashes and describe your quad setup to help with identifying the cause of your challenges.
 

traw1234

Member
So I think it might have to do with one of my motors failing. Every single time it drops off to one side(which makes me think that one of the motors/ESCs are faulty). There isn't much more to describe, unfortunately. I was flying, the quad dropped to one side, and it could not recover. I did notice that when it was falling, the motors were on. I'm not sure if they turned on after all being shut off or they were always on. All 3 were also at about 25-30 feet.
 

jbrumberg

Member
What size battery, what brand ESC's do you have ,and did all your crashes happen at about the same point in time flight-wise? It could be the ESC's LVC's (or one of them) are/is set too high, but I am certainly no expert on ESC's nor their settings.

There can be many reasons- bad solder points, loose connections, etc.

Hopefully more knowledgeable and experienced posters will post.
 

traw1234

Member
So I think it is an ESC. They are Mystery 30A ESCs. I am running off a 3S 5500 LiPo. I just tried turning it on and one motor didn't even move. The ESC was also struggling to beep. It was really odd, the ESC would beep at different lengths in no pattern. It seemed to beep more often when I moved it around. It was also the ESC that I had to resolder the bullet connector to(inside the actual ESC) so some damage could have been caused there.
 

Top