Motors start at different throttle % and run uneven??

sirlouw

New Member
Hi,
I have bought a Quadcopter kit and it has been giving me a hard time sorting out the problems.

Well im stuck with this problem, the problem is that Motor 1 and 2 start spinning at 7% and motor 4 14% and motor 3 first starts at 54% and they talso run very uneven.
My ESC´s are all throttle calibrated.

Does anybody have a solution?

My setup is:
Motors: DYS 2300KV
ESC´s: EMAX Simon Series 12A
Radio: Spektrum DX6 G2
Receiver: Spektrum 610

Any help is very much appreciated :) This is very frustrating for me :/

Thanks Sean
 

Hexacrafter

Manufacturer
Is this connected directly to the RX or the FC?
If directly to the RX, then I would say they are not properly calibrabrated for throttle range.
If on FC, which one?
If they all spool up normal when connected to the RX, then it must be releated to the FC.
If it is a DJI FC, you may wish to check the MOTOR IDLE SPEED settings and bump it up a notch to see if this helps....
But wierd for sure.....
When you say they run uneven... do you been they are sputtering and struggling to stay running..... this is MOTOR Timing settings on the ESC....
You may wish to check all of the ESC settings with a programming card- Timing, Braking, ...etc and make sure they are correct set for multirotor use as this could also be a problem.
 

Top