Motors 2 & 4

Hi friends - just switched out the stock Gaui 18 amp ESC's for the Turnigy Plush 30 amp ones and have them powering the Scorpion 960kv motors.. I used the Turnigy programming card and am very happy with the ease of use.

Here's the problem: When I start up the motors on the quad (no blades) at low stick motors 2 & 4 are last to start and it seems if I get below 40% they darn near stop. At 50% throttle I can even use my finger and slow them down almost to a stop. Motors 1 & 3 are perfect speed.

When I connect the motors individually to the reciever they start and stop perfectly.. I am using the Woo Kong system too. It almost sounds as if the ESC does not know where low and hi stick are? Is that possible?? What have I done wrong???
 

Top