Bartman
Welcome to MultiRotorForums.com!!
I've got the new firmware loaded and after a successful flight I'm feeling cautiously optimistic. The camera controls seem smoother and more competent so, whether or not that was an intentional part of the update, I'm happy.
I had trouble though with the compass calibration. When I did the first combination of stick inputs I'd get two beeps followed by three beeps with the second stick input. At this point the FC should be "clicking" but mine wasn't. After a few tries and some time searching the internet I found that if I went through all the stick inputs in succession (without doing any of the turning and calibrating stuff), then did the first stick combination again, I'd get one beep and I was able to then go through the process of calibration as it's advertised to work.
I have the older Navi board with the add-on MK Mag board. The newer boards with the integrated mag compass may not have this issue.
Bart
I had trouble though with the compass calibration. When I did the first combination of stick inputs I'd get two beeps followed by three beeps with the second stick input. At this point the FC should be "clicking" but mine wasn't. After a few tries and some time searching the internet I found that if I went through all the stick inputs in succession (without doing any of the turning and calibrating stuff), then did the first stick combination again, I'd get one beep and I was able to then go through the process of calibration as it's advertised to work.
I have the older Navi board with the add-on MK Mag board. The newer boards with the integrated mag compass may not have this issue.
Bart
Last edited by a moderator:
