vispaaja
Member
Just got my first Multiwii copter from flyduino.com. The frame is 25cm Warthox frame with built in power distribution. The build took about 6 hours and the initial set up was easy, just needed to upload the new firmware and assign the ACC channel.
I just love to fly this thing! It doesn't wobble at all and is very stable in high speeds. I'm going to increase the flip rate a bit to get more agility.
The setup:
NanoWii
T-Motor MT2212 980kv
Flyduino NFET 20A ESC SimonK FW
8x4.5 props
View attachment 7860
I just love to fly this thing! It doesn't wobble at all and is very stable in high speeds. I'm going to increase the flip rate a bit to get more agility.
The setup:
NanoWii
T-Motor MT2212 980kv
Flyduino NFET 20A ESC SimonK FW
8x4.5 props
View attachment 7860
Attachments
Last edited by a moderator: