cory lanahan
Member
hello I have two turnigy nano-tech 3000 mah 25-50c discharge, 2 cell 7.4v in a factory made harness for my hexacopter. Motors are DJI 2312/960kv and turnigy plush 30A esc. With Naza lite FC. It works fine with one battery just not enough power or flight time. Do I need to solder on some type of resistor or is my 16 awg wiring not thick enough? It also started to melt battery connection on PDB, do I need better quality board?? It got so hot with two lipos in parallel that it melted both bullet connectors off the wiring harness! What am I doing wrong please help! I've researched this quite a bit with no answer concerning this type of issue
Last edited by a moderator: